Which command sets IGRP as the routing protocol for
autonomous system 100?
A. Router(config)#igrp 100
B. Router(config)#network 100
C. Router(config)#router igrp 100
D. Router(config)#enable igrp 100
2. What are the valid ways to segment a LAN? (Choose all that apply) A. Repeater B. Bridge C. Switch D. Router
thnx jitender...its me shridh...m working for SG ltd..the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected?? plz tel me jitender how to resolve ths problem? as u sd loop in switch is the primary cause of ths....i wanna know how to resolve it...thnx for ur replys jitender sinha.
How are internetworks created?
Based upon the exhibit, create a static route to 172.16.10.0 on Router A A.) Router# ip route 172.16.10.0 255.255.255.0 10.1.0.2 B.) Router(config)# ip static route 172.16.10.0 255.255.255.0 10.1.0.2 C.) Router(config)# ip route 172.16.10.0 10.1.0.2 D.) Router(config)# ip route 172.16.10.0 255.255.255.0 10.1.0.2
What is DHCP stand for?
What is meant arp and rarp?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
Define the different kinds of casting
Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port
hi all.. can any one explain the complete topology of stp and rstp how it works . root swtch connects to a root port and then root port conenct to other switchs designated port. i was going thru his site http://www.cisco.com/en/US/tech/tk389/tk621/technologies_whi te_paper09186a0080094cfa.shtml in which DR also exist on root switch only which makes my understanding grim.I had a diff notion of stp all together. please post asap. and if possible refer a url so thst i can read it my self .. thanks
hi i am facing one problem.ptoblem is like that i am getting output error on mine router ethernet interfae here is the cisco#show interface e0 Ethernet0 is up, line protocol is up Hardware is QUICC Ethernet, address is 0030.802d.2a17 (bia 0030.802d.2a17) Internet address is 202.122.20.225/28 MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255 Encapsulation ARPA, loopback not set, keepalive set (10 sec) ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:00, output 00:00:00, output hang never Last clearing of "show interface" counters 05:55:07 Queueing strategy: fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 10000 bits/sec, 11 packets/sec 5 minute output rate 29000 bits/sec, 11 packets/sec 1515202 packets input, 359100396 bytes, 1 no buffer Received 6 broadcasts, 0 runts, 0 giants, 1 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 input packets with dribble condition detected 1584394 packets output, 1623395338 bytes, 0 underruns 1820 output errors, 26732 collisions, 0 interface resets 0 babbles, 0 late collision, 9698 deferred 18 lost carrier, 0 no carrier 0 output buffer failures, 0 output buffers swapped out output cisco# what is the reason how to solve this please tell me i am using cisco asa 5520 behid mine internet router and no error on the asa inside interface
What are four benefits that can result from applying ISDN networking? (Choose four) A. Full time connectivity across the ISDN is spoofed by Cisco IOS routers using dial on demand routing (DDR) B. Small Once and Home Once sites can be economically supported with ISDN Basic Rate Interface (BRI) servkps C. ISDN replaces Signaling System 7 (SS7) in the Public Switched Telephone Network (PSTIC) backbone D. ISDN can be used as a backup service for a leased line connection between the remote and central chaps E. Modem racking and cabling can be eliminated by integration of digital modem cards on Cisco IOS Network Acess Servers (NAS)