Interested to Buy Any Domain ? << Click Here >> for more details...
What are the two most common request/reply pair with ICMP
messages when using the ping command? (Choose two)
A. echo reply
B. echo request
C. source quench
D. fragment onset
E. information redirect
F. destination reachable
G. echo control message
- 1 Answers
- 7266 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: A, B
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?
What route entry will be assigned to dead or invalid route in case of RIP?
Name the vtp modes?
What are 10base5 ethernet lans?
Explain the term 'unicast'.
What is the checksum?
Mention what does the clock rate do?
How do you configure a cisco router for routing ipx?
What is the difference between ‘bit rate’ and ‘baud rate’?
Which protocol works only on cisco routers?
Explain the difference between routing and routed protocols?
Which type of transmission bus topology support?
Which multicast ip eigrp protocol use?
What are the ranges for the private ips?
Can you explain the broader steps of how L2F establishes the tunnel?
