Interested to Buy Any Domain ? << Click Here >> for more details...
What is the most common layer 2 device?
A. Hub
B. Router
C. Switch
D. Repeater
- 7 Answers
- 14799 Views
- CISOC, Wipro, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
What is CIDR?
Hi- Salmaan my name is Shadab Khan and nick Khangkp ok salmaam plz tell me about of NAT plz
How much hold down time of eigrep protocol?
What is the subnet? Why is it used?
Which IP host address range is allowable given an IP address of 172.37.2.56 and 12 bits of subnetting A. 172.37.2.48 to 172.37.2.63 B. 172.37.2.48 to 172.37.2.62 C. 172.37.2.49 to 172.37.2.62 D. 172.37.2.49 to 172.37.2.63 E. 172.37.2.55 to 172.37.2.126
Utilizing RIP, what is the limit when it comes to number of hops?
Why twist in twisted pairs?
Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a
What is cisco?
what is burst rate
What is the size of ipv4?
Which statement is true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not a the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth
CCNA 
