Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following are examples of the Network Layer?
A.) Token Ring
B.) LLC
C.) SQL
D.) IP
E.) TCP
F.) IPX
- 3 Answers
- 5674 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: D F
Other Network Layer protocols also include Appletalk and
DECnet. TCP is
considered to be at a higher Layer, because it provides
guaranteed data
delivery.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / haja bahurudeen m
Answer : D, F
A,B - Layer 2
C - Layer 5
E - Layer 3
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / gaurav kumar dubey
d)ip network layer
f)ipx network layer
| Is This Answer Correct ? | 0 Yes | 0 No |
Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip
Why is UDP lease favored when compared to TCP?
Which of the following is an example of the Session Layer? A.) TCP B.) SQL C.) IP D.) X-Windows E.) Token Ring F.) LLC
You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet
Which of the following are Session Layer standards? A.) ASCII and EBCDIC B.) MPEG and MIDI C.) RPC and SQL D.) JPEG and PICT
How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Router(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run
Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?
Interface 0/0 what does it mean?
To monitor ipx traffic on a network, what command would you use? A. debug ipx transaction B. show ipx traffic C. show ipx events D. display ipx traffic
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0
What is quality of ipv6?
CCNA 
