Interested to Buy Any Domain ? << Click Here >> for more details...
Given the global configuration command 'banner motd #7 Hello #',
what do the '#' symbols represent?
A.) Escape sequence to exit the menu.
B.) Nothing, just part of the banner.
C.) Tic Tac Toe Macro.
D.) Delimiting Character
E.) Message border character.
F.) Number of times message to be displayed.
- 1 Answers
- 3897 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: D
Delimiting characters allow you to have a message the is
more than one
line. You simply type as many lines as you want, ending with the
delimiting (terminating) character.
| Is This Answer Correct ? | 2 Yes | 0 No |
Identify 2 HDLC characteristics? A.) Default serial encapsulation B.) Open standard C.) Supports Stacker compression D.) Supports point-to-point and multipoint
What is the mau?
What is GRE in PPTP?
What are two characteristics of the RARP protocol? (Choose two) A. it generates parameter problem messages B. it maps IP addresses to Ethernet addresses C. it maps Ethernet addresses to IP addresses D. it is implemented directly on top of the data link layer
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21
When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised
What not a name of an ISP? A. MSN B. Comcast C. Verizon D. McDonalds
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay
Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router
What is the difference among straight cable, cross cable and rollover cable?
When we use standard access-list?
CCNA 
