Wnat do you know about zenpeck
Answers were Sorted based on User's Feedback
Answer / manoj
xenpeck is a fiber optic module used to convert electrical
signal into optical used to send data at long distance
connected to a metro ether switch because xenpack have
amplifier because of which the distance a optical signal
travels is around 20km.
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / shaikh sadik
xenpeck is the fiber module converter to convert electrical
singnal in to optical signal with very long distance
covering 25 km without any loss
| Is This Answer Correct ? | 0 Yes | 0 No |
Which type of switching reads just the address portion of the frame and then immediately starts forwarding it? A.) Cut-Through B.) Store-and-Forward C.) Tabling D.) Routing E.) Inverse ARP F.) Fast Forward
Which mode called privilege mode?
Which type of updates eigrp protocol do?
Which command should you use to confound a router so that it can become a TFTP server host for a router system image that is run in a Flash? A. copy flash tftp B. config tftp server C. write, network -router name- D. tftp-server system -file name- E. setup server tftp -system name-
Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link
When we do default route?
What information is provided by the local management interface (LMI)? A.) LMI encapsulation type B.) The current DLCI values C.) The status of virtual circuits D.) The global or local significance of the DLCI values
As system administrator, you type "debug ipx sap" and receive the following lines as part of the IOS response: type 0x4, "HELLO2", 199.0002.0003.0006 (451), 2 hops type 0x4, "HELLO1", 199.0002.0003.0008 (451), 2 hops What does "0x4" signify? A. That is a Get Nearest Server response. B. That it is a General query. C. That it is a General response. D. That it is a Get Nearest Server request.
What is the Broadcast IP Address?
Hi, Jitendra/Shahin You both are masters of networking na. I am worrying about my exam. Is it vey tough?because my friend got failed in ccna. he is very talented person thogh he failed.
What is a Window in networking terms?
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share