Answer / guest

Answer: B

The 2 most important ISDN specifications are Q & I:

Q - Call setup and teardown.

I - Concepts and terminology.

Which frame has a Type field to identify the upper-layer protocol? A.) 802.3 B.) 802.2 C.) 802.5 D.) Ethernet_II

1 Answers  

---

Which addresses are valid host addresses? A. 201.222.5.17 B. 201.222.5.18 C. 201.222.5.16 D. 201.222.5.19 E. 201.222.5.31

2 Answers   VGH,

---

LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server

2 Answers  

---

When we use interface mode?

0 Answers  

---

in router we use config# ip host router2 ipaddress we use it for ping the neighbor router using name provided by us ..........instead of ip address in this max how many ip address can be assigned thanks

1 Answers  

---

---

The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments

1 Answers  

---

what is stub router

11 Answers   Satyam,

---

Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24

1 Answers  

---

in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please

4 Answers  

---

IP RIP routing is conferred on a router but not all interfaces attach to RIP networks. What should you use to prevent all RIP routing updates from being sent through selecedc interfaces without using access lists? A. passive route B. default routes C. passive interface D. route update filtering

2 Answers  

---

What is a function of a reliable transport layer connection? A. route selection B. acknowledgements C. session checkpoints D. system authentication

2 Answers  

---

Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department

1 Answers  

---