Which of the following is a characteristic of a switch, but
not of
a repeater?
A.) Switches forward packets based on the IPX or IP address
in the frame
B.) Switches forward packets based on the IP address in the
frame
C.) Switches forward packets based on the MAC address in the
frame
D.) Switches forward packets based only on the IP address in
the packet
- 2 Answers
- 12582 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: C
A repeater regenerates the signal it receives, a switch
makes decisions
based upon MAC addresses to determine whether a frame should be
forwarded. Repeaters forward all packets.
| Is This Answer Correct ? | 9 Yes | 0 No |
Answer / m haja bahurudeen
Ans :C
Layer2 devices Switch,Bridge
Switch forward packets to perticular destination hardware
address.
Layer2 - Mac address
Layer3 - IP address
| Is This Answer Correct ? | 3 Yes | 1 No |
Define logical topology.
What is poe (power over ethernet)?
Explain how many types of router?
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
What is the mesh network?
What is the command to manually enter a static route? A.) IP route network B.) IP route C.) IP route < destination network> D.) IP route
Explain the draw back of eigrp protocol?
What are the protocol data units (pdu) in ccna?
Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0
Why we use debug command?
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
Which of the following are examples of the Datalink Layer? A.) LLC B.) SQL C.) TCP D.) Token Ring E.) IP
CCNA 
