Answer / guest

Answer: A C E

Routers can learn paths via 3 different sources; static
routes, dynamic

routing protocols (i.e. RIP) and default routes.

Identify the 3 methods routers learn paths to destinations? A.) Dynamic routing B.) None of the above, configured by default C.) Default routes D.) Administrative distance E.) Static routes

1 Answers  

---

What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable

2 Answers  

---

What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count

2 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains

1 Answers  

---

How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds

1 Answers  

---

What is wide-mouth frog?

4 Answers   Wipro,

---

Put the following steps of encapsulation into the correct order: 1) The data is broken into segments to be organized 2) Frames are converted to 1s and 0s to be put on the wire 3) Packets are converted into frames 4) Information that users enter is converted into data 5) The segments are changed to packets to be routed A.) 4, 1, 3, 2, 5 B.) 4, 5, 1, 3, 2 C.) 2, 3, 1, 4, 5 D.) 4, 1, 5, 3, 2

1 Answers  

---

Which command will show you if you have a DTE or DCE cable connected to an interface?

4 Answers   DFSS,

---

Which two commands show your access lists? (Choose two) A. show filters B. show access-lists C. show ip access-lists D. show running-config

2 Answers  

---

What is the size of an ip address?

0 Answers  

---

Identify the command to configure the router to boot from an IOS located on a TFTP server? A.) boot system tftp IOS.exe 172.16.5.1 B.) boot system tftp 172.16.5.1 IOS.exe C.) boot system flash tftp 172.16.5.1 D.) boot system IOS.exe 172.16.5.1

2 Answers   HCL,

---

Hi all, suppose more than two network administrators are configure same router with different configuration through telnet at the same time.. then whose(admin's) configuration will use router for routing ?

2 Answers  

---