DRAW IN BRIEF THE ORGANISATION STRUCTURE OF THE COMPANY WHERE YOU ARE PRESENTLY EMPLOYED / LAST EMPLOYED, INDICATING TWO LEVELS ABOVE AND ONE LEVEL BELOW YOUR POSITION2 19491
Explain No & Nc concept used in allen bradley plc? What is sink and sourse module?How you will use No,Nc concept in sink and sourse module?4 15084
what are 5 important point of TS?1234
What is the difference between preventive-maintenance and periodic-maintenance?2811
What is the difference between predictive-maintenance and proactive-maintenance?2 8712
ANY ONE USED/INTERFACED CITECT VERSION 6.0/1 OR 7.0/1 TO SIEMENS S7-300 OR S7-400 CONTROLLER IF PLEASE TELL ME THE COMMUNICATION STRUCTURE AND ADDRESS CONSIDERATION FOR DI,DO,AI,AO please mail the details email@example.com Ph:09247513753 hyderabad1082
if salary paid per month rs. 16000/- of female <65 i will deduct tds from his salary please what i will do explain?1278
if salary paid per month rs. 50000/- of male <65 i will deduct tds from his salary please what i will do explain?1157
Share with us about a time when you had to present a proposal to a person of higher position and were able to do it successfully?1063
what is the electronic presipitator ?2 2860
How three wire proximity can be used in place of two wire proximity?
How to check DC Motor & SERVO Motor?
What is alternator & engine general protection?
On what bases time study methods can be calculated?
how to find earth pit resistance in simple method?
how could you change gas line control valve to liquid line valve?
What is vendor development? What is the logistics transport control?
What happen if we install flow meter with orifice plate, but bevel position is in upstream and not in downstream
What you know about iso 9001? What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
What is total quality control? Mention the technical standards.
what is alternater & engine genral protection?
What is process planning?
Where is the catting plane line located when a section view is in dicated?
how to find rmc plant MD?
why we use log files in QTP?