Answer Posted / krishna
ohms law states the relation between voltge ,current and
resistor
V=I*R
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
explain the functions of main isolation switches
Currently what is the highest capacity (MVA) of SPPg generator available in the market?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
what is the saturation point of crgo lamination.
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
can the measured percentage error during calibration of single phase energy meter be negative?
What is the formula to calculate the rating of power cable for three phase current.
what do you mean by every IC 74 first digit.why are you using this no.why not using another no.
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
Draw a SLD of DG distribution up to main LT panel?
what is the reqirred voltage in HT motor to get full RPM on no load test?
what is the basic need of domestic loads 1- voltage 2- current
why ten delta testing is carried out on power transformer
Define noise?
