What is protocol testing. whether u have used any tool in
telecom testing.
- 8 Answers
- 45159 Views
- Alcatel, Huawei, Nokia, NSN, TATA, TelCom, I also Faced
- E-Mail Answers
Answer Posted / suraj bisht
Protocol testing means to test the functionality of the
node(piece of software) which should compliance to some
standard message flow. For this one should take a
tester(Testing Unit) which should send standard messages to
the node(Item under test). Above all tester mentioned are
good but according to me K1297-G20(Tektronics)is the best
tester.
Advantages
1) Many standard Protocol are supported by this tester
2) One can add just new protocol supports easily
3) With introduction of G-20 its interface is really good,
one can easily learn.
Disadvantages
1) Load can't be tested with this, as this tester is windows
based with low processing capabilities
2) It is little bit costly as it give license per link per
protocol base
3) Support too have some issues
I think because of its high cost small companies don't use
it and also big shots doesn't have enough number K1297-G20
| Is This Answer Correct ? | 14 Yes | 6 No |
Post New Answer View All Answers
Question on protocol testing and deployment
Explain snmp protocol? How is snmp work with nms and ems?
What is the purpose of gsm device and what is gprs?
Explain ping?
How to Force a SunOS Machine Not to Be a Router?
How to Use in.routed?
Explain snmp protocol?
How Routing Starts Up?
What is ifconfig?
Which transport layer protocols are used for VoIP audio and video payload?
How to Set a Netmask under SunOS?
Explain rrc states in umts?
In gsm we use msrn for routing but what parameter is used in the cdma for routing?
What are the different Types of Polling in RLC A.M Mode
What is IP addresses, Netmasks and Subnets?
