can we use 220 volt 15 w a.c. lamp on 220 volt d.c.
- 11 Answers
- 19338 Views
- Philips, I also Faced
- E-Mail Answers
Answer Posted / lakshmi narayanan
YES, IF IT IS AN INCANDESCENT LAMP.
wat ravindran said s right
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
What is the percentage loss for aluminium wire for HT line more than 11KVa
Igfet is a
is there any phase difference occurs while primary and secondary side mutual induction occurs?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
