What is the working of SCM CT
or purpose in genrator ?
- 3 Answers
- 8945 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / r p pandey
SCM ct are connected in field exciter circuit through SCM bridge, when high current encrease in main circuit then it protect our generator by controling excitation.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is oscillator circuit?
What is difference between slip rings and carbon burushes?
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
what kinds of Transformer oil grade is better for power transformer ?
which type of questions asking for solar companies?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
what is the meaning of 5% droop or 7% droop in AVR?
how to test reverse power trip?
how choose conductor&depending upon load
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
Is there any abbrevation for STUB in Stub bus protection
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
