In transformer which temp should be less oil temp are
winding temp?
- 7 Answers
- 14519 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / prabhakar jha
oil temperature should be less then winding temperature.winding temperature depends on Load.so oil temperature should be less for cooling transformer winding..
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why do we perform an open-circuit test and short-circuit test on the transformer?
Single line diagram for dbb (double bus bar)system.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
Can anyone explain me about the capacitor calculation
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
What is the difference between Static and servo controlled voltage stablizer?
What is electrical grounding?
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
why do we not use equivalent voltage source in negative sequence equivalent ckt.
what & how to check the lightning arrester
what work will do diffrential realay DG set
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
