What is the working of SCM CT
or purpose in genrator ?
- 3 Answers
- 8930 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / radhakrishnan
QDC CT is using to manage the AVR according to load change. SCM CT is using to manage the excitation energy requirement during short circuit.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
show the single line diagram of star delta starter with single phase preventer
what are the interview question asked in wind mill about electrical
WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
how to calculate maximum current
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What are the conditions for sustained oscillator or what is backhouse criterion?
what is the constructional difference between a power transformer and potentian transformer?
how net resistance islow in star connection and viseversa in delta connection...? if anybody could explain in detail it wud be helpful.
