125Kva Dg can take up how much amphere load.
- 7 Answers
- 35995 Views
- Indian Railways, I also Faced
- E-Mail Answers
Answer Posted / sk aminul hossain
Amp=kva*p.f/volt*root3 So
125*1000*0.85/415*1.732 (k=1000,v=415,p.f=0.85) reactive power
So, amper=147.81A or 148A
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Why the earth to phase voltage is high 250 compare to other two phases
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
derive DC RMS value for half wave rectifier?
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
What is the effect of positive feedback on the stability of the systems?
What is the ratio of Booster transformer?
how does WTI work ?
mccb service sittings be done?
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
what is the formula for computing cable tray size & capacity
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
iam preparing for rrb section engineer post in electrical branch.suggest the right textbook for my reference.fromwhere i will get the previous q.papers?
