How to Convert horsepower to kva?
what is the three phase formula?
explain me if u can Example..i have 50Hp Moter how can i
convert in kva tell me formula three phases
Rehan Smileavail@msn.com
Answer Posted / edward
The automatic calculation hp to kva is in these pages:
http://www.calculatorsconversion.com/en/hp-to-kva-calculators-conversion/
Also
KVA, KW, KVA Conversion (http://ncalculators.com/electrical/kva-conversion.htm
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the main parts of central chiller plant? Explain the function of each stage.
How to do stting of vl250 siemens MCCB
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
what is the pre charge circuit,what will be work which function it will be use plz tell me
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
What is the exact formula for one weber of magnetic flux?
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
what is Fault level? why it is calculated? how will u decide same for our plant?
Can you explain about TEE protection scheme?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
what is the constructional difference between a power transformer and potentian transformer?
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
On a 3 winding transformer YNynd11, how do you apply REF protection to the Delta tertiary winding that is supplying auxiliaries to a substation?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?