2.5mva transformer is installed in our company with oltc
but it is not working in auto mode ,it is operative in
manual mode control wiring is done how can i rectify it?
- 5 Answers
- 5751 Views
- Imdaad, I also Faced
- E-Mail Answers
Answer Posted / naveen
Oltc worked with reverse- forward motor starter through in built programmed pcb card ,command taken from this card as per voltage observation whether voltage level to be raised or down .Voltage level can be also manually controlled via selector switch.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
How can a equal potential zone be carried out in conductors?
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
What is the physical significant of power factor?
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
What is meant by full pitched winding?
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
Can we put 3 layers of cable tray while installing tray
how we calculate the withstansing current capacity of wires&cables?
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
