what is the essential difference between DIODE and SCR in
term of application.
Answer Posted / faiyaz ahmad
Diode is semiconductor device its two terminal anode and cathode it will work only two direction either forward and reverse anode is Positive terminal and cathode is negative terminal the electron will be flow positive to negative according to direction if diode will be forward bias if diode will be reverse bias then just opposite and SCR is three terminal device anode cathode and gate third terminal is used to switching and amplifying the circuit
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
can we create an interrupt in plc through scada?
can you provide me full detail about instrumentation in ONGC??
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
Which products are available in the Mass Systemswitch and System Manager AC range?
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
Can please tell mi about SIOS, PRM, SERVER, and what is the diference between PIN LAN, PCS LAN,APC Server, and please send the Doc if possible for referance,mail id patil_amit17@yahoo.com
Question on maha cement
How to calibrate an pressure gauge with yantrika test bench?
How the sizing of the analog signal cable is calculate?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
How INtools is useful for routine Instrument maintenance?