How to calibrate DP tramitter in flow measurement
application? consider my range of flow is 0 to 2000 kg/hr ?
please give calculation of , How much pressure applied on
low pressure side and high pressure side please give detail
of calculation ....
It so important for me please reply as soon as possible
- 1 Answers
- 2227 Views
- I also Faced
- E-Mail Answers
Answer Posted / suresh agravat
0 to 2000 kg/cm2 range
Formula:- URV-LRV=Span/4
2000-0=2000
2000/4=500
0=4mA(0%)
500=8mA(25%)
1000=12mA(50%)
1500=16mA(75%)
2000=20mA(100%)
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Why MUX JB's are using only Temperature Element in Fundation field bus?
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
Where is wet leg is used?
Who to difference between analog in & analog out in dcs?
How will you test a transistor with a multimeter?
what effects a surging can produce in the compressor
How to Calibrate Level Switch in field
Explain plc level and its type?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
types of cable..? Use of every types of cable..?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
what is 24vdc live and dry supply
what is cems analyzer explain with principle and drawing ?
Question on maha cement
