Interested to Buy Any Domain ? << Click Here >> for more details...
IF avr is voltage regulator of genset means why we are
giving genset CT sense to AVR ?
- 3 Answers
- 6579 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / mahadevan
The voltage feedback giving to AVR for maintaining the voltage certain(nominal) limit and current feedback giving to AVR for avoid operation above certain range of current value because OLTC operation in higher current load is risky.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Is neutral transformer can be called as control transformer?
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
what is proper capacitor placement? How to evaluate capacitor size?
. How to calculate the Short Circuit Impedance in Transformer? How to calculate the Short Circuit Impedance in Transformer?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
What are the different circuits in thermal power plant?
why constant voltage transformer should be start without load? and if started then what will happen?
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
