which relay is better , instantaneous or IDMT relay .
- 2 Answers
- 4646 Views
- I also Faced
- E-Mail Answers
Answer Posted / karthik
for metering, protection all will be taken in one CT --only core will be varied in that CT
for measurement -1s1,1s2
for protection - 2s1,2s2
only one CT is used
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
is it possible to start a motor in felid connected to a remote mcc
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
How does the phase sequence controller works, how it identifies the phases? confirm working principle
howmany electrician should maintain for a 1000 kva used plant... in kerala..
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
sir pls send the je exam - 2008 and other model question papers..
why would amp draw on neutral wire be as much as amp draw on the hot leg.
describe the Tranformer testing procedure
what is cathodic protaction?
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
STATE WORKING OF VACCUM CIRCUIT BRAKER?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
how mass curve differs from hydrograph.
What is block diagram?
