how to calculate the earthing conductor & no. of earth pits
required
- 3 Answers
- 15162 Views
- I also Faced
- E-Mail Answers
Answer Posted / mrutyunjay
Dear Sudhakar Sir,
Greetings of the day !
Recently I have been through one answer shared by you and got your email id at AllInterview.com. Please kindly help me in my below concern :
Permissible current density equation i = (7.57*1000) / sqrt(resistivity * duration of earth fault) as per IS 3043
Is this equation to be taken for all types of electrodes ( Plate, Rod or Pipe & Strip ) ?
Because , as per IS 3043, same equation is appropriate for plate electrode
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
Explain how to determine capacitor tolerance codes?
for compensate 315mh inductance ,how many capaciance required?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
should %impedance be high or low in a power transformer? if so why?
can anyone provide me a amf panel control wiring using ec-2 relay?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
What is the need of generator relay panel
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
How many types of colling system it trformers?
what is arc flash and what are the hazards involved
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
