1. how much normal earth resistance in earth pits(neutral
and body earth) and transformer neutral and body earth &
panel earth.
Answer Posted / kalpesh
Earth pit resistance 1.4 TO 1.6 NORMAL CNDITION
Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
What is open loop and control loop systems?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
Why Ac Systems Are Preferred Over Dc Systems?
What is the effect of pd controller on system performance?
Why do power lines not short out when they fall into water?
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
can i use the six sigma method which is used in management area, in state estimation of power systems?
how ceiling fan worked?