if you asked to choose a ckt breaker from MCB & MCCB for 32A
which one will be best and why??
Answer Posted / sahedul islam sagor
MCCB tripping Capacity is low when MCB. We know a machine starting current is high but its running current is normal if we used MCB it will trip instant with starting current but if we use MCCB it will take a little time for running machine.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
what the principle of sincroscope?how it works?when it needed?
what do u understand from filter factor of reactor?
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
Please brief working principle & construction of permanent magnet AC Servo motor
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
explain supply side and demand side energy management with advantages & disadvantages
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
specific difference of ICT&Auto Transformer
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?