What will happen when we connect 2 bulbs in series between 2
phases
- 7 Answers
- 14865 Views
- Pepsi, PowerTech, I also Faced
- E-Mail Answers
Answer Posted / huzy
Assuming 2 phase means 430 V and 2 bulbs means 2 lamps of 230 V each. Under this condition of connecting 2 lamps of 230V in series across 430V supply of 2 phase will glow the lamp at their rated voltage and current with normal glow of light.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what is sevice settings for mccb?How can be it setted?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
Why syn. Generators are used for the production of electricity?
why the NGR (neutral grounding resistor) always OFF during DG off?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
Define active and passive network?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
for a 400kv t/m line with 10 ampere current will corona occur?
What is the diff. between single compression and double compression gland
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
what is difference between 2 pole structure and 4 pole structure in transformer yard
What is the height of DA, DAL, DB, DC & DDE tower?
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
could you measure current in parallel?
