Interested to Buy Any Domain ? << Click Here >> for more details...
What should be percentage of silt content in sand?
- 21 Answers
- 80654 Views
- I also Faced
- E-Mail Answers
Answer Posted / adesh kumar dohare
As per IS 383 Silt percentage in Content of sand minimum 3% and maximum 8%.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
How to determine thee cut length for steel reinforcement bars in R.C.C design
who to find building iron rod strenth
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
Would you cause a 55-gallon drum of water to weigh more by climbing in?
how much cement and sand consuptin in 4 inch siporex walls 100 sq ft
how pumping of concrete effects the quantity of material used in it?
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
List out some of the software program that can be useful for architect?
Basic questions of civil engineering
what are the duties of Site Engineer in work site?
please what is the number of bars required for a column of 6mx6m and 450mmx300mm,its a commercial building (Church)
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
What is the best type of wood glue?
Time required for curing of wall tiles before fixing
