why should a transformer be never connected to dc supply
- 5 Answers
- 6698 Views
- I also Faced
- E-Mail Answers
Answer Posted / sivakumar
it mean we are applying dc(constant) current to coil ,voltage is zero across inductor(transformer winding) so there is a short circuit occuring so it draws high current
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the differance between HT motors And LT MOTORS.
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
what is doid
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
What are the special cables required for explosion proof wiring?
What is transformation ratio what it describes?
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
What happen to generator if i have unbalanced load?
What are the applications of the electric motors?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
What is meant by analogous system?
what is the reqirred voltage in HT motor to get full RPM on no load test?
