can we control operation of PLC from operator station?
Answer Posted / ashish namdev
Operation station system no have any program (programming built in Engg. Station Only which is a server also)
but operating station system is connected with same network of plc/Dcs through Ethernet or other.
than that station has a SCADA software which is connect it to server system station through IP protocol.
than we can access or give command through Operating station.
Ashish Nmadev
Sr. Engg In Jaypee thermal power plant, Bina(MP)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
what is RTV function in in process control?
what is sil (safety integrity level
What are different types of cable?
is motorized valve closed when power shutoff?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Explain the working of an electronic level troll.
How does your previous experience relate to the job you are applying for ?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
what is function of SCADA , and how is it work, explain with difination
what is gas metering system? gas chromatograph? and gas compressors?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
How to Calibrate Flammable gas detector in field