Answer Posted / joksha
When a core is surrounded by primary and secondary coil ,when current is allowed through the coil then EMF is produced
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How cable from Kit-Kat to main switch, from starter to motor are designed?
what is arc flash and what are the hazards involved
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
low frequency protection why recomend?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
What Maximam Gap Taibaar & Bush
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
plese send me the oces/dgfs sylabus and previous year question pattern of electrical engg.?
What type interview questions ask in Electrical technicians
what can be the causes of capacitor start motor having a higher current that its actual
what is mean by transition resistance of transformer?
Define filter?
why tertiary winding is used in transformer with diagram?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
