Interested to Buy Any Domain ? << Click Here >> for more details...
What is the use of starter in tube light fitting.how it works.
- 3 Answers
- 7963 Views
- JSW, I also Faced
- E-Mail Answers
Answer Posted / biswa
More clarification needed. the choke coil(iron core
inductor) gives rise to the high voltage e=L.(di/dt) where L
is the inductance of the coil. the voltage induced is in the
range of 800-100 volts a.c. this voltage ionizes the gas and
the tube glows
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
I had applied for JE in PSEB, Can you pls send me the Question bank for related to my field
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How to know of any cable size if there are not written on cabl?
Starting Time of LT & HT Motor
Compare jfet’s and mosfet’s.
should %impedance be high or low in a power transformer? if so why?
what is model question rrb junior engineer electrical gr.II
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
how will we calculate the copper wire load..
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
