Answer Posted / mahalingam

The switches all are working in Digital mode.Like 0 or 1. To do the calibration confirm the NO & NC. Basically it is NC when the process reaches the desired level then the circuit will be NO.

What is difference between radial vibration and axial vibration explain in detail .

1726

---

Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?

2470

---

What is solenoid valve? Where it is used?

1121

---

what is sliding spool valves?

2244

---

How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?

2030

---

What is hp & mp seperator .& what is its working principle ?

2240

---

What is Erosion in a control valve?

2154

---

Speedtronic system .

1982

---

what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?

1992

---

Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions? 

2189

---

what is metal of piston ring

1935

---

Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,

1701

---

A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe

2258

---

is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?

2229

---

Explain the difference between mmwc and mmwg?

5677

---