How to calculate the ups battery back up? give the formula.
- 15 Answers
- 105918 Views
- Cushman Wakefield, Ethio Telecom, Exide, MacLellan, Morgan Stanley, TATA, I also Faced
- E-Mail Answers
Answer Posted / narayanarao.s
back up( in hours)= system dc volts x AH rating(
battery)/kva(load)x system power factor.
| Is This Answer Correct ? | 11 Yes | 5 No |
Post New Answer View All Answers
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
what are the ''pitting rings''and how cn they be controlled in a series generator
what is the effect of higher value of GD???
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
what happen ehen synchronisation is done at below rated speed
why should the primary of transformer be connected in delta in a heat run test?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
What is meant by positive and negative feedback?
how to maintain frenquncy with syncronising sub-station for distribution
When we connect the large capacitor bank in series ?
how does this job compare with others you have aplied for?
how to calculate mf when meter and cTPT detail are given
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
