How to know actual capacity of Ethernet port by command line?
(Sun Fire V480 and some one configured Eth interface as
100mbps and need to change to 1000mbps but How i would know
that port is of capacity 1000mbps or not?
Answer Posted / teja
Hi
Normally this setup can be done by network team..if network
team change the value 1000mb it will come by default MAC
speed is 1000Mb if you want manually change from OS
end..you can use
#ndd -set <Attribute> <Mode of speed>
Sol10 can work to see the speed
dladm show-dev
i hope sol10 earlier versionit can work with ndd and kstat
command
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Hi We have upgraded our sun machine from solaris 9 to solaris 10. Before upgradation the date command output(Solaris 9) Wed Oct 13 09:45:21 IST 2010 But after upgradation the output for date is as below(solaris 10). Wednesday, October 13, 2010 9:46:14 AM IST Looks like I need to change LC_TIME=C. can you please help me how to change it for permanently
How can u find a file which is logged in last week?
How to configure email notification in solaris 8? We are using netbackup 5
please post step by step installation of packages from the EIS cd..
Which command is used to backup and restore solaris file system?
what is the difference between solaris8 and solaris9 and solaris10
Where do you get Alarm prompt?
Write the steps involved in creating and executing a program to implement the “case” command.
If the root disk is failed how can change it?
What does pkgadd command do?
What are the differences between the command line and graphical user interface?
How to create core dump and crash dump #coreadm .
How to make SUN server as router in subnetwork?
There are two nic cards on a sun server. I need to connect one nic to pupic ip and another nic to DMZ. Could you tell me how to configure step by step?
what are the alarms in solaris?