What will happen if we give the 3 phase supply to the rotor
of slipring induction motor?
- 3 Answers
- 4220 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjeev sharma
Three phase supply can be given to the rotor of slipring
motor for testing purpose. it just work like supply given to
the secondary side of transformer & measure voltage on the
primary side. So give supply to the rotor of slipring motor
& check voltage across stator terminal
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
Why is a plain induction motor unsuitable for wide speed control?
what is the difference b/w pvc cu conductor and cu breaded wire..?
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
Explain bypass capacitor?
What is resonant frequency?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
how does the thyistor work in dc drive?
what will happen if frequency is below 50 hz?
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?
What is power factor why we should maintain the power factor unless what will happen
What is meant by celling voltage & current in excitor ?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
