Why is starter necessary for a three-phase induction motor?
Answer Posted / saravanan.s.r.
Starter is mainly used inorder to reduce the HIGH STARTING
CURRENT and to protect the electrical equipments.at the
time of starting the slip=1;speed=less; hence the rotor
resistance value equals '0' due to the relation r2(1-s)/s.
there is no back emf,such that it draws a high starting
current.It may lead to damage the equipments in motor.hence
to avoid this starter is used.main types of starters are
1.Direct On Line starter.
2.Auto Transformer starter.
3.Rotor Resistance starter.
4.Star - Delta starter.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
working function importance of mdc meter
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
Transmission through a short line depends on
What products have you designed which have entered high volume production?
what is the clear formula to calculate cable size for a load
what is the formula for computing cable tray size & capacity
how do u gauge the size of the cable ?for eg. consider a 300 sqmm L.T Cable.How do u determine the size of the cable seeing it pratically?
circuit diagram of trip circuit supervision relay
If we want to change a contactor of faulty one what are the conditions want to fullfil
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
How to do maintenance of transformer feeder.
what is the max. acceptable leakage current in 33kv bus bar
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?