Interested to Buy Any Domain ? << Click Here >> for more details...
can we change the range of 3151 model level transmitter of
rosemount make? present calibration range is 1000mmwc and
want to change it to 2000mmwc
- 4 Answers
- 8380 Views
- I also Faced
- E-Mail Answers
Answer Posted / narayan
Check Tx data sheet or engraved plate on the tx and it gives span limit as 2000mm, then we can change
if it is below 2000 mm, we can not change, or calibrate
it is sensor range
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how is work pressure switch& level switch?what is the principle of this?
What is the differerence between hysterisis and linearity.
How to Calibrate Radar Level Transmitter in Field
why we are using magnet for calibration of gas detector?
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
Why trim span ? How?
can you provide me full detail about instrumentation in ONGC??
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
How to fix back the valve actuator stem
Reason for capillary type dp level transmitter fluctuation
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
