1 liter emulsion paint covered how much area?
- 17 Answers
- 112197 Views
- Asian Alliance Insurance, Aspirtek, DEWA, L&T, I also Faced
- E-Mail Answers
Answer Posted / vigneshwaran s
It may be 100 to 105 Sq.ft (incl.Wastage)
Regards,
Vignesh selvaji (VGN).
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
HOE TO YOU PLAN TO ACCHIEVE THE GOALS?
The properties of concrete HA-30 and how does it differ with M 30 (specify the important characteristics like workability,strength,mix design,slump test value)and what is the standard relating to it
on what basis the partial factor of safety are decided? form the load combinations
Special thing in designing a overhead reservoir ? which is different from an ordinary design
How to calculate brick work quantity?? Block work quantity??
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
WHAT WII BE THE WATER ABSORPTION POWER OF WOOD ?
how to calculate 1:5:8 ratio concrete cement, sand, metal and water please give me brief calculation
I want to know the material required per Square foot in rcc roof i.e.Steel ,Cement,
Exterior Joints,define
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
How to calculate the quantity of ingredients of M20 grade concrete?
Define What is passive earth pressure ?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
What are the alternate material for steel, Sand and aggregate
