Can we pass 11kv power in 1.1kV voltage grade cable.If not why?.
- 3 Answers
- 9832 Views
- I also Faced
- E-Mail Answers
Answer Posted / sheikh
No we cannot use 1.1kv voltage grade cable to pass 11kv because in thise case must be consider voltage grade of cable.
normally 15kv grade cable may used to passing 11kv
and this is a standard.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
what is meant by moulded case circuit breaker ?
how to flameproof electrical motor on the shaft?
Define cuttoff frequency?
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
What is VSCF windelectrical system?
How one can check the MAIN of a house wiring ?
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
how to synchronize 3 phase slip ring induction motors of different ratings.
how can calculate 1kva generator running time in 1 liter keroscene
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
what is the necessity of under ground cables ??
If any cable burnt how can we identify it burnt by high current of high voltage?
