how to calculate the cable size for 500 kva transformer?
Answer Posted / dharmendra
post your full question input cable or output cable
you can use V1xI1=V2XI2
Is This Answer Correct ? | 6 Yes | 11 No |
Post New Answer View All Answers
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
What will be in Mahagenco Trade Test Exam? I want to know the same.
What is difference between start imitation and start interlock for 3 phase motor protection ?
difference bewteen reverse current and alternating current
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
Power Factor Correction Panel (Manual & Automatic)
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
When we need up only in o/p 440v, so why we use directly in 11kva in input?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at thiru.1203@gmail.com
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel