why the motor running in delta connection ? it can be in star?
- 13 Answers
- 53391 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / samir vyas
Its a matter of torque which is low in star because of reduced voltage at
winding and at designed load star connected motor get stopped due to
insufficient torque. More you have to see motor characteristic at diff.
Stage
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is mean by drives?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
In parallel operation time both NGR’s close or not close if both close what will happen
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
what is level 2 automation?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
Explain cmrr?
how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?
The windings of a transformer are divided into several coils, because?
What is class ab operation?
Define what is the function of anti-pumping in circuit breaker?
What is polar plot?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
what is lrs tank water resistance.
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
