Is it recommended to apply H.pot test for new cables
segments after terminations or joints, however, this cable
has been tested before at the manufactor by the vendor ? or
only we can apply megger tests ?
Answer Posted / sudhakar g
Hpot is the test we can do if any cable damage happend or any leakage of current....Every cables must be tested before they sent to consumer and the test certificates also provided when ever we buy that product....Before terminated to any transformer or panels or any equipment...We have to do the megger test because if there is any cable damage while we are laying the cable....If you go for high rise buildings it is recommended use Rising main, you will tap the supply from the Rising main and main advantage is voltage drop is not occur compare to cable laying.......
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
what are the factors to be considered while design the breaker either HT or LT??
What is different between Difnit time and instatous over current relay
how we design a pannel to start 10HP motor with the help of star delta starter?
what is draiv work
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
what is smartµ grid technology?under coal gassification?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
What are the types of transformers according to the arrangement of iron cores?
Why do we perform an open-circuit test and short-circuit test on the transformer?
What is the purpose of stand by earth fault protection for transformer ?