Answer Posted / kesavan
if 1 TR = 12000 BTU
1 BTU = 0.29 w
so 1 TR = 12000 x 0.29 = 3480 w
approximately
1 TR = 3500 w (or) 3.5 kw
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
iam preparing for rrb section engineer post in electrical branch.suggest the right textbook for my reference.fromwhere i will get the previous q.papers?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
What is knee point voltage?
Any one can explaination about calibration with rotating sub standards?
Why we cant store an ac power. If we coo store in which device we can?
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
along with technical test papers
How to calculate cable size in HT AND LT
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
what is the mechanical safety of DG ?
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
