how lap length is increased with increase of Grade of steel?
- 2 Answers
- 25295 Views
- I also Faced
- E-Mail Answers
Answer Posted / bilal ali khan
development length mostly used when beam bar are passing through column and are simply shown as ld+10d
for fe500 ld is
m40-36d
m35-40d
m30-46d
m25-49d
m20-57d
for fe415 ld is
m40-30d
m35-30d
m30-38d
m25-41d
m20-47d
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
what is raft foundation
How to testing voids of filled aggregate in bitumen mix design
i have applied 40mm spacer in the concrete for tie beam. is it correct? kindly give me if there any code available
what is the venturi effect in buildings? what is green house concept?different types of dams? which dam is economical arch dam or gravity dam. what are the conditions favourible to both of them?
why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..
how to calibrate the RM 800
how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?
Stringer How many cm goes to landind
How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel
how many numbers of 4inch bricks and get consumed in 9 inch BB masonary wall in cubic feet.plz send my below e.mail adress
Rate analysis of Vitrified tile in cement mortor 1:3
How do you maintain water pressure?
Whats the standard thickness of 20'/30' wide rcc service road and what will be the estimated cost per cubit feet
What is labor and material payment bond?
how to absorb to site basic corrections? which are the important correction?
