I HAVE GOT TYPICAL PROBLEM WITH THE TEMP.INDICATION.
THE PROBLEM IS THE K-TYPE T/COUPLE OUT PUT IS CONNECTED TO
A INDICATOR.THE INDICATION FLUCTUATES SOME TIMES AND SOME
TIME IT IS STABLE.
WHEN I CHECKED OUT PUT OF T/COUPLE THE MV WILL NOT VARY.
WHERE AS INDICATION FLUCTUATES.
WHEN I GIVE MV SOURCE TO T/COUPLE EXTENSIONCABLE FROM THE
FIELD IT INDICATION IS STABLE.
WHEN GIVE MV SORCE TO INDICATOR ITS INDICATION IS STABLE.
PLEASE CLARIFY.
- 5 Answers
- 5826 Views
- I also Faced
- E-Mail Answers
Answer Posted / sreedhar
Just Replace T/C
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
where cascade loop use ?
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
what is function of switch, and how is it work, explain with difination
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
Explain signal isolator
what is effect of specific gravity in differential level transmitter , explain formula related with this .
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
Manipulation of dead wt. tester double piston type.
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
what is the responsibility of an instrument commissioning supervisor
If P will increase then what will happen with PID?
Why boiler chimney area oxyden sensor fixing?
