Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sathish
it is an branch of engineering that deals with measurement, monitoring, controlling of various kinds of energy exchange which take place during process operation
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
In turbine, what does term CDP, NI, NH, HSSOC, means
Explain an adaptive / self-tuning controller’s major draw card.
What is the difference between uv and ir scanners? and what is the workig principle of both
what is the calibration procedure for transweigh make weigh feeder?
where cascade loop use ?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
define feed forward control loop with example and drawing?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
how to convert cubic metre per hour to newton cubic metre per hour
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
why we are using digital signals for I/O & how to measure this signals is getting or not ?
What is limitation of the ht.of the displacer of a level trol?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
