Why do you get a typical sound when the transformer is put into operation?
- 4 Answers
- 6721 Views
- IIT, I also Faced
- E-Mail Answers
Answer Posted / mgalalkhedr
This is normal due to thr inrush current. the sound can be
heared for one to two sec.. some times and according to the
relay settings the transformer may be tripped on over
current and it is normal
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
What are the essential characteristics of signal flow graphs?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
what is the difference b/w pvc cu conductor and cu breaded wire..?
What is the general power factor & min. power rating of TV,LCD type TV, CRt type TV, Scanner, printer?
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.
wat is the first thing dat is needed, 2 lay a cable in some area??
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
how to differentiate a mpcb,mcb with a contactor? Explain their working operation
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
What are n circles?
What are the different types of controllers?
condition Autotrip facia come on control panel of electrical transmission line?
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
