i want use pressure transmitter for flow ,how?
- 5 Answers
- 8429 Views
- Gasco, I also Faced
- E-Mail Answers
Answer Posted / sudarsun
Differential Pressure transducer along with a Venturi pipe
should do the work. The pressure at the normal diameter vs
the pressure at the shorter diameter should be proportional
to the rate at which the fluid flows.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How d.p. Transmitter can be applied to open tank?
is motorized valve closed when power shutoff?
types of cable..? Use of every types of cable..?
what is the usage of QDV & VOLUME BOOSTER
plz send me general of ongc
flow transmitter formula?
What is PDS and PDMS ?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
With N nodes and B branches what will have a network ???
what is the vital subject for scoring bhel exam&what is the question pattern
How is flow measured in square root?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
why orfice is not used for main steam flow calculation
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
