Interested to Buy Any Domain ? << Click Here >> for more details...
How much RPM in Turbocharger in Diesel engine.
- 9 Answers
- 46780 Views
- Greaves, MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / kumar
maximum 125000rpm for the turboharger
| Is This Answer Correct ? | 13 Yes | 13 No |
Post New Answer View All Answers
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
what are the steps involved in generator load test?
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
boiler is running in rankine cycle and deisel generator is....?
what is the maintaining Cf in UPS.
What OPGW is better than Microwave or PLCC???
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
Can we put 3 layers of cable tray while installing tray
Explain in brief description about the operation of DG sets.
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
what will happens if one phase is missing for 33/11kv power transfomer and why?
why core is useful for a transformer ?and also in its operation ?
